Design and implementation of multichannel signal source based on FPGA

Home > Archive>Volume 44, Issue 11, 2021 >136-140

Design and implementation of multichannel signal source based on FPGA
DOI:
                        
                    
CSTR:
                        [cstr]
                    
Author:
                        Feng YuhangFeng Yuhang
Science and Technology on Electronic Test and Measurement Laboratory; Key Laboratory of Instrumentation Science and Dynamic Measurement, Ministry of Education, North University of China, Taiyuan, 030051, china
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site
Ren YongfengRen Yongfeng
Science and Technology on Electronic Test and Measurement Laboratory; Key Laboratory of Instrumentation Science and Dynamic Measurement, Ministry of Education, North University of China, Taiyuan, 030051, china
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site
Liu DonghaiLiu Donghai
Science and Technology on Electronic Test and Measurement Laboratory; Key Laboratory of Instrumentation Science and Dynamic Measurement, Ministry of Education, North University of China, Taiyuan, 030051, china
Find this author on All Journals
Find this author on BaiDu
Search for this author on this site

                    
Affiliation:Science and Technology on Electronic Test and Measurement Laboratory; Key Laboratory of Instrumentation Science and Dynamic Measurement, Ministry of Education, North University of China, Taiyuan, 030051, china
Clc Number:TN911
Fund Project:

Article

Figures

Metrics

Reference

Cited by

Materials

Comments

Abstract:

Aiming at the complexity of current DA conversion and its conditioning circuit of multichannel signal source, combined with the requirements for analog signal sources , a multichannel analog signal source based on FPGA and PCI bus is designed. The board takes FPGA as the system controller, PCI9054 as PCI bus protocol chip, 100V analog voltage is generated by boost chip lm5022, and the output is controlled by aqy277a Optical MOS Relay of NAIS company; 23 channels of 0-28v adjustable analog voltage are converted by 6 four channel DA conversion chip ad5504. Finally, the calibration coefficient of the upper computer is used to improve the accuracy of output voltage. The results show that the board can output the voltage reliably, and the stability is high, and meets the design requirements.

Key words:PCI; analog signal source; LM5022;AD5504

Get Citation

Copy

Article Metrics

Abstract:
PDF:
HTML:
Cited by:

History

Received:
Revised:
Adopted:
Online: September 18,2024
Published:

Home

Introduction

Editorial Committee

Policy

Contact Us

中文版

Get Citation

Share

Article Metrics

History

Article QR Code